Cal Flame BBQ10900 Gas Grill User Manual


  Open as PDF
of 32
 
Appendix
27
Hibachi Grill
LTR50001096, Rev. A
www.calamebbq.com
Step 2: Changing the burner orices
Remove the griddle from the 1.
grill.
Remove the cotter pins from 2.
the end of the burners. The
cotter pins are accessible from
underneath the grill in the back
in the accessory cabinet.
Carefully remove the burner.3.
Using a 6mm socket or nut driver, remove the orice for the 4.
burner.
Apply a small amount of pipe compound to the orice threads.5.
Screw in the orice until it is nger tight.6.
Tighten the orice with the 6mm wrench.7.
Repeat the above steps for the remaining burners.8.
Replace the burners and griddle. (You do not need to replace 9.
the cotter pins if you do not wish to.)
Mark the rating plate
After conversion has been completed, mark the rating plate as NG
with an indelible marker.
You will need:
6 mm socket or nut •
driver
Two 1.9 mm orices •
Pipe compound suit-
able for natural gas
 previous next