Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
8
Installation / Assembly
Hibachi Grill
LTR50001096, Rev. A
www.calamebbq.com
Natural Gas
Requirements
Always check the rating plate to make sure the gas supply you are
hooking up to is the gas type the grill is manufactured for.
IMPORTANT: Never connect the grill to an unregulated gas supply.
The installation of this appliance must conform with local codes or,
in the absence of local codes, to the national fuel gas code, ANSI
Z223.1a-1998. Installation in Canada must be in accordance with the
standard CAN/CGA-B149.2, Propane Installation Code.
A licensed contractor or local gas company representative must per-
form all natural gas connections.
Ensure that the service supplying the grill is tted with a shut off valve
conveniently positioned near the grill and giving ease of access.
The grill must be isolated from the gas supply piping system by closing
its individual manual shutoff valve during any pressure testing of the
gas supply piping system at test pressures equal to or less than 0.5 psi
(3.5 kPa).
The grill and its individual shutoff valve must be disconnected from the
gas supply piping system during any pressure testing of that system at
test pressure in excess of 0.5 psi (3.5 kPa).
Your Cal Flame grill for use with natural gas comes equipped with its
own regulator that MUST NOT be removed. If this regulator needs to
be replaced, use only the type specied by Cal Flame for this appli-
ance.
Connection
Slide the grill forward to gain access to the regulator and gas con-1.
nection point in the rear.
Connect a suitable ex connector to the grill regulator.2.
Check the grill controls to ensure all control valves are in the full 3.
OFF position.
Turn on the main gas supply and check all connections for leaks 4.
using soapy water as described in the leak testing procedure sec-
tion.
Warning: If you see bubbles in the soapy solution at any of the connec-
tions, turn off the gas supply and tighten the connection. If tightening
the connection does not seal the leak, it may be necessary to replace
the ex hose.