Cal Flame Barbeque Grill Gas Grill User Manual


 
Appendix
2007 Barbecue Grill and Cart Owner’s Manual Page 25
LTR20071038, Rev. B
Appendix
Troubleshooting
Problem: Smell of gas is present
Solution: Check for loose connections in the gas line. Perform a leak test following the procedure described in
this manual.
Problem Burner does not ignite
Solution Use the following procedure with the gure below.
Check the position of the sparker tip. It should be pointing forward towards the front of the burner.
Make sure there is a blue spark at the electrode tip to the burner.
Make sure the igniter wire is connected rmly to the valve ignition device and the electrode.
Make sure the valve orice is free of any debris, dust or grease.
Make sure the valve orice is aligned inside the front hole of the burner.
If there is no spark at all, replace the electrode or igniter wire.
Note: Turn off the gas at the source while troubleshooting.
Problem: Burner tube is misaligned over the orice
Solution: Reposition the burner tube so that it is properly seated over the orice.
Problem: Obstruction in the gas line
Solution: Remove the fuel line from grill. (Do not smoke or perform any maintenance in the vicinity of an
open ame.) Open the gas valve for one second to blow out any debris. Close off the gas valve and
reconnect the fuel line securely.
Problem: Yellow Flame
Solution: Once the entire burner is operating, check the ame color to be sure that it is mostly blue. Some
yellow at the tips may be present due to impurities in the fuel. If the ame is golden or yellow in
color, the reason could be seasoning salts, oil lm, or other foreign matter on the burner.