Cal Flame Barbecue Grills & Carts Gas Grill User Manual


  Open as PDF
of 28
 
2009 Barbecue Grills and Carts
LTR20091038, Rev. A
Appendix
www.calspas.com
22
Step2:Changingtheburnerorices
Replacetheinfraredburnerorices1.
Using a 13mm wrench, remove the orice for the infrared burner.a.
Apply pipe compound to the tting threads where you will place the b.
new orice.
Screw on the correct orice for your grill until it is nger tight.c.
Tighten the orice with the 13mm wrench.d.
If you have dual infrared burners, repeat the previous steps for the e.
second burner.
Replace the back cover.f.
Replacethesideburnerorices2.
Remove the grate, burner cap and burner diffuser from the side a.
burner.
Using a 7mm wrench, remove the orice for the burner.b.
Apply a small amount of pipe compound to the orice threads.c.
Screw in the orice until it is nger tight.d.
Tighten the orice with the 7mm wrench.e.
If you have dual side burners, repeat the previous steps for the f.
second burner.
Replacethemainburnerorices3.
Remove the grates, ame tamers, and drip tray from the grill.a.
Remove the cotter pins from the end of the burners. The cotter pins b.
are accessible from underneath the grill in the back in the accessory
cabinet.
Carefully remove the burner.c.
Using a 6mm socket or nut driver, remove the orice for the d.
burner.
Apply a small amount of pipe compound to the orice threads.e.
Screw in the orice until it is nger tight.f.
Tighten the orice with the 6mm wrench.g.
Repeat the above steps for the remaining burners.h.
Replace the burners, cotter pins, ame tamers, drip tray, and grates.i.
Apply the sticker4.
After conversion has been completed, apply the enclosed sticker to the rating plate. The sticker reads “This
unit has been converted from LP to NG.”
You will need:
6mm socket or nut •
driver
Two to ve 1.9mm •
orices (depending on
your grill
Pipe compound•
You will need:
13mm open end •
wrench
One #50 orice (for •
single infrared burner)
Two #54 orices (for •
dual infrared burners)
Pipe compound•
You will need:
7mm wrench, socket, •
or nut driver
One or two 1.75mm •
orices (depending on
your side burner)
Pipe compound•
 previous next