Cal Flame Barbecue Grills & Carts Gas Grill User Manual


 
2009 Barbecue Grills and Carts
LTR20091038, Rev. A
Appendix
www.calspas.com
21
All Cal Heat grills are manufactured as standard liquid propane (LP) grills and can be converted to burn
natural gas (NG). There are two steps required to convert a grill from LP to NG. You must perform
both steps.
Step 1: Switching the regulator behind the grill
Step2:Changingtheburnerorices
You will need some or all of the ttings (depending
on the size of the grill or cart) contained in
the conversion kit provided with the grill. The
conversion kit contains orices to convert ve
main burners, two small rear infrared burners,
one large infrared burner, and two side burners.
You will not need all of the parts in the kit.
Before you begin, make certain the LP gas source
has been disconnected from the grill. If you have
a cart, you do not need to remove the grill from
the cart.
To gain access to the NG regulator:
For grills, tilt the grill forward.
For barbecue carts, remove the back cover.
Step 1: Switching the regulator behind the grill
The regulator in the image below has been removed from a grill to illustrate this
procedure.
Remove the LP gas line.1.
Remove the cap tting from the end of the NG gas regulator.2.
Place the cap tting over the LP gas inlet.3.
Insert the 3/4” ared in the NG gas regulator.4.
Converting from LP to NG
WARNING! You must have an authorized service technician perform this
procedure.Iftheseinstructionsarenotfollowedexactly,areorexplosionmay
result causing property damage, personal injury or loss of life. Lloyd’s Material
Supply (L.M.S.) will not be held responsible for an improperly converted gas grill.
You will need:
13mm open end
wrench
3/4” ared tting
Pipe compound