Cal Flame Barbecue Grills & Carts Gas Grill User Manual


 
2009 Barbecue Grills and Carts
LTR20091038, Rev. A
Using Your Grill
www.calspas.com
12
Inspect the hose before using the grill. If there
is excessive abrasion or wear, or if the hose is
cut, it must be replaced prior to using the grill. If
you need a replacement hose, contact your Cal
Flame dealer.
Ensure the area around the barbecue is clear
of ammable substances such as gasoline, yard
debris, wood, etc.
Ensure there is no blockage of the airow
through the vent space located below the face
of the unit.
When using propane gas:
Keep the special ventilation openings in •
the enclosure free and clear of debris.
If connected to a propane cylinder, •
carefully inspect the rubber hose
attached to the regulator before each
use.
Ensure the propane cylinder, regulator, •
and rubber hose are installed in a
location not subject to heating above
125º F (51º C).
Ensure the burner ames burn evenly along both
sides of each burner with a steady ame (mostly
blue with yellow tipping). If burner ames are not
normal, check the orice and burner for insects
or insect nests.
Ensure the in-line gas valve or gas cylinder valve
is always shut OFF when the barbecue is not in
use.
Do not operate the side burner with its cover closed
or the back burner with its cover installed.
Electronically Lighting the Grill and
Infrared Burners
Open the hood.1.
Keep your face as far away from the burners 2.
as possible.
Rapidly rotate the burner knob counter 3.
clockwise past the light position to HIGH. You
will hear a loud click as the electronic lighter
produces a spark.
Listen for the sound of the gas igniting. If the 4.
burner does not light on the rst try, repeat
immediately.
If the burner does not light after three 5.
attempts, turn the control knobs to the OFF
position. Wait ve minutes until the gas clears
before attempting to light it again.
Repeat the procedure or try the manual lighting 6.
procedure below.
Upon successful lighting, repeat the process on 7.
the other burners you wish to light.
To shut off the burners, rotate the knob and 8.
turn to OFF. It is normal to hear a popping
sound when the burners are turned off.
Lighting the Grill
Each time you light the grill, check the following:
Manually Lighting the Grill and
Infrared Burners
WARNING: Do not use standard matches or
cigarette lighters to perform match lighting
procedures. Serious burns can occur and lighters
can explode.
Open the hood.1.
If you have just attempted to light the burner, 2.
allow ve minutes for any accumulated gas to
dissipate.
Slide out the drip tray from the grill.3.
Keep your face as far away from the burners 4.
as possible.
Light and insert a long stem match, holding it 5.
near the burner ports.
Push in and turn the control knob just past the 6.
LIGHT position to HIGH.
Listen for the sound of the gas igniting. If the 7.
burner does not light after ve seconds, turn
the control knobs to the OFF position. Wait ve
minutes until the gas clears before attempting
to light it again.
If the burner does not light after several 8.
attempts see Troubleshooting Guide in the
back of this manual.