Cal Flame Barbecue Grills & Carts Gas Grill User Manual


 
2009 Barbecue Grills and Carts
LTR20091038, Rev. A
Appendix
www.calspas.com
19
Appendix
Troubleshooting
Problem: Smell of gas is present
Solution: Check for loose connections in the gas line. Perform a leak test following the procedure
described in this manual.
Problem: Burner does not ignite
Solution: Use the following procedure with the gure below.
Check the position of the sparker tip. It should be pointing forward towards the front of
the burner.
Make sure there is a blue spark at the electrode tip to the burner.
Make sure the igniter wire is connected rmly to the valve ignition device and the
electrode.
Make sure the valve orice is free of any debris, dust or grease.
Make sure the valve orice is aligned inside the front hole of the burner.
If there is no spark at all, replace the electrode or igniter wire.
Note: Turn off the gas at the source while troubleshooting.
Problem: Burnertubeismisalignedovertheorice
Solution: Reposition the burner tube so that it is properly seated over the orice.
Problem: Obstruction in the gas line
Solution: Remove the fuel line from grill. (Do not smoke or perform any maintenance in the vicinity
of an open ame.) Open the gas valve for one second to blow out any debris. Close off the
gas valve and reconnect the fuel line securely.