Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Problems and Solutions 29
4. When the green power
light stops flashing, make sure paper is loaded
in the printer, then do the following:
Windows: Click
Print Nozzle Check Pattern. Then click Print.
Macintosh: Click
Confirmation, then click Next.
The nozzle check pattern prints.
5. If the nozzle check pattern has no gaps or white
lines as shown, click
Finish.
If the pattern has gaps, click
Clean to clean the
print head again.
You can also turn the printer off and wait
overnight—this allows any dried ink to soften—
and then try cleaning the print head again.
■ The ink cartridges may need replacing; see page 21 for instructions.
Your printout is blurry or smeared.
■ Make sure the printable (whiter) side of the paper is face-up.
■ Use Epson papers to ensure proper saturation and absorption of genuine
Epson ink.
Your paper doesn’t feed correctly or jams in the printer.
■ If multiple pages feed at once, remove the paper from the sheet feeder, fan the
edges to separate the sheets, then reload it.
■ If paper jams, press the paper button for several seconds to clear the jam.
If that doesn’t work, open the cover and pull the paper out from the front,
including small pieces that may have torn off. Reload the paper and press the
paper button.
■ Heavily saturated prints may curl, causing a paper jam when printing on both
sides of the paper.
■ Make sure you use new, smooth, high-quality paper, loaded printable side up.
Don’t load paper above the arrow mark inside the left edge guide. Place the
paper against the right edge, behind the tab. Slide the left edge guide against
it, but not too tightly.