Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Buy Weber Grill Parts. It couldn't be easier. Find your Weber parts here.
WWW.WEBER.COM
®
25
Summary lighting instructions are posted
on the cart leg under the burner control
knobs.
BURNER IGNITION & USAGE
BURNER IGNITION
Electronic Ignition System
The electronic ignition system ignites the burner with a
spark from the igniter electrode inside the Gas Catcher™
ignition chamber. You generate the energy for the spark by
pushing the igniter button. You will hear the igniter clicking.
A) Open the grill lid (1).
m DANGER
Failure to open the lid before igniting
the grill’s burners, or not waiting five
minutes to allow the gas to clear if the
grill does not light, may result in an
explosive flare-up which can cause
serious bodily injury or death.
B) Make sure ALL burner control knobs are turned
off(2). Check by pushing burner control knobs in and
turning them clockwise until they stop.
C) Turn the gas supply valve on (3).
D) Light the outside burner by pushing the large burner
control knob in and turning it counterclockwise to
start/high ( ) position (4).
E) Push and hold in the igniter button (5). You will hear
the igniter clicking.
F) Check that the burner is lit by looking through the
cooking grates. You should see a flame.
m WARNING: While igniting the grill or
cooking, never lean over open grill.
m WARNING: If the burner fails to ignite
within five seconds, stop, turn the
burner control knob to off and wait
five minutes to allow the gas to clear
before you try again or light with a
match.
G) After the outside burner is lit, you can turn on the
inside burner. Push in the small burner control knob
and turn it to start/high ( ) position (6). The inside
burner will then be ignited by the outside burner.
TO EXTINGUISH BURNER
Push each burner control knob in and turn it clockwise to
the off ( ) position. Turn gas supply off at the source.
Some batteries have a plastic
protective wrap around them.
This plastic must be removed
before you attempt to ignite
your grill. Do not confuse this
plastic with the battery label.
METHODS OF BURNER
IGNITION
There are two ways to ignite
the burner. The first is by
using the ignition system built
into your grill. The second is
with a match.
Next are the steps for igniting
your grill using the ignition
system. On the following page
are steps for igniting your grill
with a match.
5
1
2
4
6
3