Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
To remove the main burners for cleaning:
1. Locate the burner screw at the rear of the firebox.
2. Remove the screw and lift the burner out of the firebox.
To clean the grill burners:
1. Clean the exterior of the burner with a wire brush. Use a metal scraper for stubborn stains or debris.
2. Clear clogged ports with a straightened paper clip. Never use a wooden toothpick as it may break off
and clog the port.
3. Check and clean burners / venturi tubes for insects and insect nests. A
clogged tube can lead to a fire beneath, and behind the main control panel.
Fig. 24
To reinstall the main burners:
1. Insert the burner over the main burner gas valve (Item# 28 on
Page 28).
2. Make sure the orifice spud (A) is inside the burner venturi (B) as
shown in fig. 24.
3. Align the burner screw hole with the firebox hole, insert screw
and tighten.
Flame Characteristics
Check for proper burner flame characteristics. Burner flames should be blue and stable with no yellow tips,
excessive noise, or lifting as shown in fig. 25. The following steps should be followed for correcting the
flame characteristics:
1. Turn the control knobs and Liquid Propane cylinder valves “OFF”.
2. Allow the grill and burners to cool.
3. If the flame is yellow (not enough air), turn the adjustment screw found at the front of the burner
counterclockwise.
4. If the flame is noisy or lifts away from the burner (too much air), turn the adjustment screw
clockwise.
5. If these adjustments do not correct the problem, contact customer service at 1-877-323-5263.
B
A
CAUTION
1. Keep outdoor cooking gas appliance area clear and free from
combustible materials, gasoline and other flammable vapors
and liquids.
2. Do not obstruct the flow of combustible and ventilation air.
3. Keep the ventilation opening(s) of the enclosure free and clear
from debris.
Fig. 25
23