Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
blue and stable with no yellow tips, excessive noise or lifting. Yellow flames indicate insufficient air.
Noisy flames or flames that lift away from the burner indicate too much air (See the “Flame
Characteristics” section on page 23).
TO LIGHT THE ROTISSERIE BURNER
1. Open the lid, push and turn rear burner knob slowly to “IGNITE/ON” setting; simultaneously press the
electronic ignition button to light the burner.
2. Once the burner is lit, release the electronic ignition button and knob.
3. If ignition does not occur in 5 seconds, turn the knob to “OFF”, wait 5 minutes and then repeat the
lighting procedure or light by match.
TO LIGHT THE SEARING SIDE BURNER
1. Push and turn sear burner knob slowly to “IGNITE/ON” setting; simultaneously to press the electronic
ignition button to light the burner.
2. Once the burner is lit, release the electronic ignition button and knob.
3. If Ignition does not occur in 5 seconds, turn the knob to “OFF”, wait for 5 minutes and then repeat the
lighting procedure or light by match
TO MATCH LIGHT THE GRILL
If a burner will not light after several attempts using the control knobs, the burners may be lit with a match.
WARNING
CAUTION
When lighting, keep your face and hands as far
When using a match to light the grill make sure to
away from the grill as possible.
use the attached lighting rod.
CAUTION
Remove the warming rack when using a match to
light the rotisserie burner.
Fig. 21
B
Main Burner
1. If you have already attempted to light the main burner with
the igniter, allow 5 minutes for any accumulated gas to
dissipate.
2. Insert a match into the lighting rod (A) as shown in fig. 21.
Ignite the match and insert through the cooking grids (B) to
the burner.
3. Press the control knob and rotate to the “IGNITE/HI” setting,
continue to press the knob until the burner ignites. The
burner should light immediately.
A
4. If the burner does not light within seconds turn the knob to
the “OFF” position, wait 5 minutes and try again.
19