Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
1
Safety Instructions
Read carefully before assembling and
operating your Gas Grill.
INSTALLATION
This gas grill must be installed in accordance
with the local codes or if in an area without
local
codes with the latest edition of the National
Fuel Gas Codes ANSI Z223.1.In Canada,
installation must conform to the standard
CAN/CGA. 1-b149.1 and/or 2 installation
Code for Gas Burning Appliances and
Equipment.
THE LOCATION FOR YOUR GRILL
Do NOT use your gas grill in garages, porches
breezeways, sheds or other enclosed areas.
Your gas grill is to be used OUTDOOR ONLY.
Always keep proper clearance from
combustible
construction, at least 21’’from the back and
side to any combustible surface that will burn.
Do not obstruct the flow of combustion and
ventilation air around the grill housing.
This outdoor cooking gas appliance is not
intended to be installed in or on recreational
vehicles and or boats.
FOR YOUR SAFETY
Do not store or use gasoline or other
flammable vapors and liquids in the vicinity of
this or any other appliance.
Do not store empty or full spare gas cylinders
under or near this or any other appliance.
Keep the fuel hose and any electrical cord
away from hot surfaces. Protect fuel hose from
dripping grease. Avoid unnecessary twisting of
hose. Visually inspect hose prior to each use
for cuts, cracks, excessive wear or other
damage. Replace hose, if necessary.
NEVER test for gas leaks with a lighted match
or open flame. NEVER light grill with lid closed
or before checking to insure burners are fully
seated over gas valve.
NEVER lean over cooking surface while
lighting grill. Use barbecue tools with wood
handles and good quality insulated oven mitts
when operating grill.
IF YOU SMELL GAS
1. Shut off gas to the appliance its
source.
2. Extinguish any open flame.
3. Open lid.
4. If odor continues, immediately call
your gas supplier.
PROTECT CHILDREN: Keep them away from
grill during use and until grill has cooled after
you are finished. Do not allow children to
operate grill.
CHECKING FOR GAS LEAKS NEVER TEST
FOR LEAKS WITH A FLAME
Prior to first use and at the beginning of each
new season(or, if using LP, whenever gas
cylinder is changed)it is a must for you to
check for gas leaks.
Follow these steps:
1. Make soap solution by missing one part
liquid detergent and one part water. Ratio
1:4 soap to water.
2. Turn off heat control valves, and then turn
on gas at source.
3. Apply the soap solution to all gas
connections. bubbles will appear in the
soap solution if connections are not
properly sealed. Tighten or repair as
necessary.
4. If you have a gas leak that you cannot
repair, turn off the gas at the source
disconnect fuel line from grill and
immediately call your grill dealer and gas
supplier for professional assistance.
LP GAS CYLINDER SAFETY
Your gas grill is designed for use with a
standard 20 Ib LP gas cylinder. DO NOT
CONNECT YOUR GRILL TO AN LP GAS
CYLINDER EXCEEDING THIS CAPACITY. A
tank of approximately 12 inches in diameter by
18-1/2 inches high should be the maximum size
tank used.
LP gas cylinder is not provided with this grill.
When you buy LP gas cylinder, be sure
that(1)the cylinder must be provided with a
shutoff valve terminating in a LP-gas supply
cylinder valve outlet specified, as applicable, for
Connection No.510 in the Standard for
Compressed Gas Cylinder Valve Outlet and Inlet
Connections, ANSI/CGA-V-1, or Connection
NO.600 in the Compressed Gas Associate’s
Limited Standard Cylinder Valve outlet
connection for Propane-Small Valve