Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
12
Cleaning &Maintenance
1. Bend a stiff wire (a light-weight coat hanger
works well)into a small hook. Run the hook
through each burner tube and into the burner
several times.
2. Using a narrow bottle brush with a flexible
handle run the brush through each burner tube
and into the burner several times.
3. Use an air hose to force air through the burner
tube and out through the burners ports.
Observe each port and make sure air comes
out every hole.
Regardless of which burner tube cleaning
procedure you use. We recommend that you
complete the following steps to help prolong burner
life.
1. Wire brush entire outer surface of burner to
remove food residue and dirt.
2. Clean any clogged ports with a stiff wire such
as an open paper clip.
3. Inspect the burner for damage(cracks or
holes)and if such damage is found, order and
install a new burner. After installation check to
insure the gas valve orifices are correctly
placed inside ends of burner tubes. Also check
position of spark electrode.
CLEANING THE GREASE TRAY
The grease tray should be emptied and wiped
down periodically and washed in a mild detergent
and warm water solution. A small amount of sand
or cat litter may be placed in bottom of grease tray
to absorb the grease.
ANNUAL CLEANING OF GRILL HOUSING
Burning-Off the grill after every cook out will keep it
ready for instant use; however once a year you
should give the entire grill a thorough cleaning to
keep it in top operating condition.
Interior:
1. Turn the burner valve off.
2. Turn the tank valve OFF fully.(Turn clockwise to
stop.)
3. DETACH the regulator assembly from tank
valve by turning the quick coupling nut
counter-clockwise.
4. Remove and clean the cooking grids, flame
tamers and burners.
5. Cover the gas valve orifices with a piece of
aluminum foil
.
6. Brush the inside and bottom of the grill with a
stiff wire brush, and wash down with a mild
soap and warm water solution. Rinse thoroughly
and let dry.
7. Remove aluminum foil from orifices and check
orifices for obstruction.
8. Check spark electrode, adjusting as instructed
electrode tip pointing toward the tip of gas
collector and approximately 3¼16”from the tip
of collector tube.
9. Replace flame tamers, cooking grids.
10. Reconnect to gas source and observe burner
flame for correct operation.
IMPORTANT: You should NOT line the bottom of
the grill housing with aluminum foil, sand or any
other grease-absorbent substance. Grease will not
be able to drip down into grease collector and a
grease fire could occur.
Exterior:
Your gas grill is made of heavy stainless steel, it
should provide you with years of trouble-free
service.
KEEPING OUTDOORS COOKING GAS
APPLIANCE AREA CLEAR AND FREE FROM
COMBUSTIBLE MATERIAL GASOLINE AND
OTHER FLAMMABLE VAPORS AND LIQUID.
KEEP THE VENTILATION OPENINGS OF THE
CYLINDER ENCLOSURE FREE AND CLEAR
FROM DEBRIS.
CLEANING THE COOKING GRIDS
After cooking ,turn control knobs to “OFF” and let
grill cook before attempting to clean your cooking
grids.
Before first use and periodically it is suggested that
you wash the cooking grids in a mild soap and
warm water solution. You can use a wash cloth, a
vegetable brush or a steel wool to clean your
cooking grids if you desire.
CLEANING THE FLAME TAMER
Washing the flame tamer after every use is not
necessary but periodically it is suggested you wash
the tamer in a soap and warm water solution. Use a
wire brush to remove stubborn burned on cooking
residure . Dry the flame tamer thoroughly before
you re-install it in the bowl.