Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
32
6. Check the Gas Collector Box to verify that there is a 3/16” gap between the electrode tip and the top flange of the
box as shown in Fig. 12.
NOTE: Before next step, you may wish to clean the rest of the grill.
See Grill Cart, Bowl and Hood (p. 30).
7. After cleaning, refit the Burner.
NOTE:
When refitting the Burner, be sure it is positioned correctly. The
valves should protrude inside the Venturi ends of the Burner. (Fig. 9)
Replace the Screws and Bolt that fasten the Burner in place.
8. If the grill is to be stored, wrap Burners in a protective cover to
keep insects out.
9. Check Burner operation after re-assembly.
10. Replace Warming Rack, Flavor Activator and Cooking Grids.
Fig. 12
Gas Collector Box - If no spark,
pinch together or open Gas
Collector Box to adjust 3/16” gap
between electrode tip and V-notch.
3/16” gap
Storage
To reduce the risk of serious bodily injury or death:
• Store your LP gas grill in a cool dry place. Do not store an LP Gas Cylinder in a space greater than 125 degrees
Fahrenheit. Never store a connected LP Gas Cylinder in a building, garage, or any enclosed area.
• Store LP Gas Cylinders outdoors out of reach of children.
• Never store an LP Gas Cylinder indoors (empty or filled) unless it is disconnected from the gas grill and the
cylinder’s Gas Supply is turned “OFF.”
• Never leave a LP Gas Cylinder inside a vehicle that can become overheated by the sun.
• Even though your LP Gas Cylinder may appear to be empty, gas may still be present and the LP Gas Cylinder
should be transported and stored accordingly.
• Never store a spare LP Gas Cylinder under or near the LP gas grill.
• Always turn off the LP Gas Cylinder at the LP Gas Cylinder valve when the gas grill is not in use.
WARNING
!
1. Disconnect LP Gas Cylinder from grill and store outside, in a dry, well-ventilated area, away from any sources of
heat or ignition. Re-cap LP Gas Cylinder valve with the Safety Cap.
2. Remove Burner and wrap with aluminum foil to prevent insects from entering the Burner holes. Store wrapped
Burner on top of Cooking Grid.
3. You may wrap the Cooking Grid and Flavor Activator in aluminum foil and place inside the Hood or store inside
your dwelling.
4. Place a grill cover over the grill and store outdoors if possible. It may be stored indoors only if the LP Gas Cylinder
is disconnected from the gas grill and stored outside.
5. Before next use, remove aluminum foil and reinstall Burner, Flavor Activator, and Cooking Grid.
6. Before using the grill after periods of storage or non-use (i.e. over winter), check your LP gas grill for gas leaks,
deterioration, proper assembly, and Burner obstructions.
7. Periodically check and tighten all nuts, bolts, and screws.