Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
26
Lighting the Grill Using the Ignitor (continued)
1. Open the Hood.
2. IMPORTANT: Make sure Control Knobs are turned “Off.” (Fig. 4)
3. Turn the LP Gas Cylinder valve open counterclockwise until it stops. (Fig. 5)
Right Main Burner
Control Knob
Igniter Button
Left Main Burner
Control Knob
Fig. 4
Control Knob in
Off position
Control Knob in High
position (large flame
symbol)
Fig. 6
4. Push far left Main Burner Control Knob in on Control Panel and turn counterclockwise to the High position.
(Figs. 4 and 6)
5. For the model 6212, push the Piezo Igniter Button several times so that it clicks each time. Look to make sure
the Burner is lit. If no spark, see Troubleshooting Section on page 33.
For the model 6512, push in and hold the electronic igniter button. Listen for the spark ignition, and look to
make sure the Burner is lit. If no spark, see Troubleshooting Section on page 33.
6. From the “Off” position, light other Burner. Your grill has a Crossover Ignition System that allows the Burners
to light successively off one another.
7. If the Burner fails to light, repeat Step 4-5. If it still does not light, try the right Burner.
If a Burner goes out during operation, turn all Control Knobs to the “Off” position and close the LP Gas Cylinder
valve to dissipate any accumulated gas. Open Hood and wait five minutes before attempting to relight the grill.
If any or all Burners fail to light after three to four attempts following Steps 4-7, turn all Control Knobs to the
“Off” position and close the LP Gas Cylinder valve to dissipate any accumulated gas. Wait five minutes; then
repeat the lighting procedures.
NOTE: If the Burners still fail to light, refer to the Troubleshooting Section on page 33. The Burner can also
be lit manually, see
Manual Lighting of the Grill on page 27.
Fig. 5
Turn LP Gas
Cylinder valve
counterclockwise