Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
11
Step 9
Drip Cup Wire Assembly
Slide the Drip Cup Wire down through the small hole in the center of the bottom of the grill Bowl. (This must be done
before attaching the burner.
Wire in position
1/4-20 Nut
8 pc
Step 8
Bowl Support & Hinge Half Assembly
A.
Attach the Bowl Supports and Flavor Activator Supports to the Bowl, orientated as shown. With the Flavor Activator
Support on the inside of the Bowl and the Bowl Support on the outside, attach both Supports to the Bowl using the same
pair of 1/4-20 x .59” Bolts, Fiber Washers and Nuts. The bolt and fiber washer are on the inside of the Bowl. Repeat this
for the other side.
B. Attach the Bowl Hinge Halves to the Bowl, oriented with the open side up. Install two 1/4-20 x .39” Bolts with Fiber
Washers through the inside of the Bowl and then the Bowl Hinge Half. Fasten in place with two Nuts. Repeat for other
hinge half.
A
A
B
Bowl Support
Flavor Activator
Support
1/4-20 x .39” Bolt
Fiber Washer
Nut
1/4-20 x .59” Bolt
Bowl Hinge Half
Bowl Support
1/4-20 x .39” Bolt
with Fiber Washer
4 pcs
1/4-20 x .59” Bolt
with Fiber Washer
4 pcs
Fiber Washer
Nut