Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Figure 1
CAUTION: While it is possible for one person to
assemble this grill, obtain assistance from another
person when handling some of the larger, heavier
pieces, especially the grill head.
1. Open Lid of shipping carton and remove top sheet of
cardboard. Lay cardboard sheet on floor and use as
a work surface to protect floor and grill parts from
scratches.
2. Slice all carton corners with a sharp utility knife to
lay open the carton panels. This will allow you to
raise the grill head Lid, remove the components
packed inside the head, and make the head easier
to lift.
3. Remove packing materials and parts boxes resting
on grill head
4. With an assistant, lift the grill head away from the
shipping carton and place it on the cardboard work
surface.
5. Open all parts boxes. Use the parts list to check
that all parts have been included.
6. Inspect the grill for damage as you assemble it. Do
not assemble or operate the grill if it appears
damaged. If there are damaged or missing parts
when you unpack the shipping box, or you have
questions during the assembly process, call:
Figure 2
CASTER
CASTER
/
BOTTOM
/SHELF
/
CART SIDE
PANEL-LEFT
CART SIDE
PANEL-RIGHT
\
SOTi-OM
SHELF
1-888-317-7642
8 a.m. - 8 p.m CST, Mon. - Fri.
Assembling The Grill Cart
NOTE: To aid in assembly, compare hardware to
diagrams on page 6
1. Turn over the Bottom Shelf on floor. Install the
4 Casters to Caster Seats on the Bottom Shelf.
Align the holes on Caster with the threaded
holes on Caster Seat. Tighten securely by
using 16 of the 1/4"xl/2" Phillips head screws
provided. See Fig. 1.
2. Before attaching the Bottom Shelf to Cart Side
Panels be sure Door Stop for Magnets on the
Bottom Shelf and holes for Door Axle Brackets
on Cart Side Panels are located on the front
side. See Fig. 2.
3. Install the Bottom Shelf between Cart Side
Panels. Align the holes on Cart Side Panels
with the threaded holes at the corners of
Bottom Shelf. Tighten securely by using 8 of
the 1/4"x50mm Phillips Head Screws provided.
See Fig. 2.
DOOR STOPS
FOR MAGNETS
Figure 3
CART SIDE
PANEL-LEFT
\
\
4. Install the Rear Panel to inside of rear Cart
Side Panels and to rear of Bottom Shelf. Align
the holes on the Rear Panel with the threaded
holes on rear Cart Side Panels and rear BOTTOM
Bottom Shelf. Tighten securely by using 7 of SHELF
the 1/4"xl/2" Phillips Head Screws provided.
See Fig. 3. 10
/
HOLES FOR DOOR
AXLE BRACKET
REAR PANEL
!
CART SlOE
PANEL-RIGHT