Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Safety Instructions
Operating Instructions
Safety Instructions
Operating Instructions Care and Cleaning
Troubleshooting Tips
Consumer Support
Problem Possible Causes What To Do
Control signals after
You forgot to enter a • Touch the
BAKE
pad and desired temperature or
entering cooking time
bake temperature or the
SELF CLEAN LO/STD
pad and desired clean time.
or start time
cleaning time.
Display goes blank
A fuse in your home may be • Replace the fuse or reset the circuit breaker.
blown or the circuit
breaker tripped.
The clock is in the • See the
Special features of your oven control
section.
black-out mode.
Display flashes
Power failure. • Reset the clock.
Unable to get the
Oven control pads were • The
BROIL HI/LO
and
BAKE
pads must be touched at
display to show “SF”
not touched properly. the same time and held for 3 seconds.
“Probe” appears in
This is reminding you to • Enter a probe temperature.
the display
enter a probe temperature
after plugging in the probe.
Power outage,
Power outage or surge. • Reset the clock. If the oven was in use, you must
clock flashes
reset it by touching the
CLEAR/OFF
pad, setting the
clock and resetting any cooking function.
Steam from the vent
When using the convection • This is normal.
feature, it is normal to see
steam coming out of the oven
vent. As the number of racks
or amount of food being
cooked increases, the amount
of visible steam will increase.
“Burning” or “oily”
This is normal in a new oven • To speed the process, set a self-clean cycle for a
odor emitting from
and will disappear in time. minimum of 3 hours. See the
Using the self-cleaning
the vent
oven section.
Strong odor
An odor from the insulation • This is temporary.
around the inside of the oven
is normal for the first few times
the oven is used.
Fan noise
A cooling fan or a convection • This is normal. The cooling fan will turn off and on
fan (depending on the to cool internal parts. It may run after the oven is
function you are using) may turned OFF. The convection fan will cycle on and off.
automatically turn on and off. until the function is over or the door is opened.
Oven racks are difficult
The gray porcelain-coated • Apply a small amount of vegetable oil to a paper
to slide
racks were improperly cleaned. towel and wipe the edges of the oven racks with the
paper towel. Do not spray with Pam
®
or other
lubricant sprays.
LOC shows in the
The Range Lock-Out feature • Be sure the surface burner controls are turned OFF.
display
is activated. Turn this feature off to use the range. See the
Range
Lock-Out
section.
ge.com
37