Enviro 50-1628 Fire Pit User Manual


 
7
AIR SHUTTER:
Air Shutter Adjustment Nut
Figure 5: Air Shutter Adjustment.
The air shutter is controlled by
sliding the air shutter adjustment
screw (shown in Figure 5) either
forwards or backwards. The
adjustment screw, for the primary
air, is located on the bottom of the
rebox. The air shutter nut can be
accessed by removing the control
panel. This is best done during the
initial installation.
Sliding the shutter forwards
increases the primary air while
sliding the shutter backwards
decreases the primary air.
The air shutter allows the amount
of air coming into the replace to be
adjusted in order to accommodate
different climates and venting
arrangements. Start the pilot and
then the burner. Make sure the pilot
ame is burning normally and none
of the burner ports are plugged. Let
the replace burn for roughly fteen
(15) minutes and then examine the
ames, compare the ames to
Figure 43 or Front Cover.
Operating Instructions
For Your Safety, Read Safety Precautions
And Lighting Instructions Before Operating
Cara
On/Off
High
Low
Off
Fan
RemoteControlReceiver
(optional)
Ignitor
Figure 4: Cara DR Control Panel.