Enviro 50-1628 Fire Pit User Manual


  Open as PDF
of 37
 
25
Figure 39: Log Placement of Right Log.
The placement of the logs is not arbitrary. If
they are positioned incorrectly, the ames
can be “pinched” and will not burn correctly.
The burner has four (4) pins and four (4)
ledges which make alignment easier. Using
the pictures provided, carefully set the logs
in place.
NOTE: The logs are fragile and should
be handled gently.
1. Carefully remove logs from box and
check there is no damage. It is very
important to install all logs in their
proper position to ensure safe, optimum
operating conditions.
2. Place the Left Rear Log Chunk on the
two (2) left rear pins and the Right Rear
Log Chunk on the two (2) right rear pins
(refer to Figures 37 and 38).
3. Place the bottom of the “Y” Log in the
ledge at the front left of the burner and
the top of the log rests on the Right
Rear Log Chunk as shown in Figure 38
and 39.
4. Place the bottom of the Right Log in the
ledge at the front right of the burner and
rest the top of the log against the rear
panel as shown in Figure 39 and 40.
Secondary Installation
INSTALLATION OF LOG SET:
Figure 37: Log Placement of Rear Log Chunks.
Left Rear
Log Chunk
Right Rear
Log Chunk
“Y” Log
Right Log
Figure 38: Log Placement of “Y” Log.
 previous next