Dimplex BF33ST/DX Fire Pit User Manual


  Open as PDF
of 34
 
2
Main Power
Switch
BF33ST, BF33DX, BF39ST, BF39DX, BF45ST, BF45DX
REMOTE CONTROL
The remote control has a range of approximately 50ft. (15.25m). It
does not have to be pointed at the fireplace and can pass through
most obstacles (including walls). It is supplied with one of 243
independent frequencies to prevent interference with other units.
The frequency designation is indicated on the back of the
transmitter (FIGURE 3).
Remote Control Initialization
This procedure is required every time there is a loss of power to the
remote control in the fireplace (i.e. power failure, breaker tripped,
main power switch is turned off)
1. Ensure that power is supplied through main service panel.
2. Access the manual controls, (remove glass doors if applicable)
pull the right hand steel curtain to the side of the unit.
(FIGURE 4)
3. Locate manual controls refer to FIGURE 5.
4. Activate main power switch, (“ ” position is “ON”, “ ” position
is “OFF”) red Level 1 indicator light will flash.
5. Press and hold the ON switch marked “ ” for five seconds.
The red Level 2 indicator light will flash.
6. Press the ON button located on the remote control transmitter
(FIGURE 3). This will synchronize the remote control
transmitter and receiver.
Remote Control Usage
The remote control operates the fireplace levels sequentially. The level is increased
every time the ON button on the transmitter is pressed. The fireplace can be turned off
at any point by pressing the OFF button on the remote control transmitter.
Level 1: The flame effect is turned on and the first red indicator light is activated.
Level 2: The flame effect remains on, the heater is activated to the low heat setting,
and the first and second red indicator lights are activated.
Level 3: The flame effect remains on, the heater is set to the high heat setting, and all
three red indicator lights are activated.
FIGURE 3
MANUAL
CONTROLS
Level 1 Indicator
Level 2 Indicator
Level 3 Indicator
On Switch
Off Switch
FIGURE 4
Frequency
Code
FIGURE 5
 previous next