Dimplex BF33ST/DX Fire Pit User Manual


  Open as PDF
of 34
 
17
BF39ST, BF39DX, BF45ST, BF45DX
If the fireplace was operating prior to servicing allow at least 10 minutes for light bulbs
and heating elements to cool off to avoid accidental burning of skin.
Disconnect circuit power before attempting any maintenance or cleaning to reduce the
risk of electric shock or damage to persons.
TO REPLACE VOLTAGE SELECTOR SWITCH
(UNIT IS PERMENANTLY INSTALLED IN WALL)
1. Remove the log grate retaining screws and remove the log grate.
2. Pull the rear edge of the log set forward by grasping the ember bed by the sides
(handle the log set only by the ember bed and not the logs) and pulling firmly
until the rear tab pops out from under the back ledge, then lift out.
3. Release the steel curtains from the side panels by opening the retainers on the
sides of the fireplace using needle nose pliers.
4. Remove the steel curtains by lifting up on the curtain mounting rod releasing it
from the side mounting tab, and pulling out.
5. Remove the heater cover mounting screws from inside the firebox and remove
the heater cover by lifting it up from the back, bowing it slightly in the center and
pulling out by one end.
6. Locate the voltage selector switch inside the exhaust panel on the top right hand
corner, and cut wire the tie wraps securing the voltage selector switch wires.
7. Remove the voltage selector wire connections from the heater elements noting
their original locations.
8. Cut and strip the brown and orange wires from the voltage selector switch along
the back panel allowing enough room to cut, strip and reconnect wiring.
9. Depress the retainer clips on the rear of the voltage selector switch and push the
switch out of the light block.
10. Properly orientate the new switch and connect all of the wiring connections to the
heater elements
NOTE: Ensure there is enough wire length to wire connect the wires together.
11. Cut and strip the brown and orange wires from the new voltage selector switch.
 previous next