Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
19
BF33ST, BF33DX, BF39ST, BF39DX, BF45ST, BF45DX
If the fireplace was operating prior to servicing allow at least 10 minutes for light bulbs
and heating elements to cool off to avoid accidental burning of skin.
Disconnect circuit power before attempting any maintenance or cleaning to reduce the
risk of electric shock or damage to persons.
TO REPLACE VOLTAGE SELECTOR SWITCH
(UNIT CAN BE REMOVED FROM WALL)
1. Remove unit from installed wall. (remove trim surround if applicable)
2. Remove a total of 4 screws from both side trims on unit.
3. Remove the 6 top panel mounting screws and position heater assembly upright
being careful not to damage any wires.
4. Locate the voltage selector switch inside the exhaust panel on the top right hand
corner, and cut the wire tie wraps securing the voltage selector switch wires.
5. Disconnect voltage selector switch wire connections from heater elements noting
their original locations.
6. Cut and strip the brown and orange wires from the voltage selector switch along
the back panel allowing enough room to cut, strip, and reconnect wiring.
7. Depress the retainer clips on the rear of the voltage selector switch and push the
switch out of the light block.
8. Properly orientate the new switch and connect all of the wiring connections to the
heater elements.
NOTE: Ensure there is enough wire length to wire connect the wires together.
9. Cut and strip the brown and orange wires from the new voltage selector switch.
10. Use (2) wire connectors to connect the 4 stripped wires with their matching
colour. (brown wire with brown wire, orange wire with orange wire)
WARNING: Ensure wires do not come in contact with moving parts by securing
wires in wiring tie wraps.
11. Reassemble in the reverse order as above.