Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
20
BF33ST, BF33DX, BF39ST, BF39DX, BF45ST, BF45DX
If the fireplace was operating prior to servicing allow at least 10 minutes for light bulbs
and heating elements to cool off to avoid accidental burning of skin.
Disconnect circuit power before attempting any maintenance or cleaning to reduce the
risk of electric shock or damage to persons.
TO REPLACE HEATING ELEMENTS
(UNIT IS PERMENANTLY INSTALLED IN WALL)
NOTE: The fireplace is equipped with two heating elements. The same removal &
installation instructions apply to both elements.
1. Remove the log grate retaining screws and remove the log grate.
2. Pull the rear edge of the log set forward by grasping the ember bed by the sides
(handle the log set only by the ember bed and not the logs) and pulling firmly
until the rear tab pops out from under the back ledge, then lift out.
3. Release the steel curtains from the side panels by opening the retainers on the
sides of the fireplace using needle nose pliers.
4. Remove the steel curtains by lifting up on the curtain mounting rod releasing it
from the side mounting tab, and pulling out.
5. Remove the heater cover mounting screws from inside the firebox and remove
the heater cover by lifting it up from the back, bowing it slightly in the center and
pulling out by one end.
6. Locate the elements mounted to the top cover and disconnect the connections
noting their original locations.
7. Remove the 2 element cover hex head screws using a ⅜” hex head socket.
8. Remove the 3 remaining element cover mounting screws and remove element.
9. Properly orientate the replacement element and connect all of the wiring
connections in their original locations.
10. Reassemble in the reverse order as above.
NOTE: To replace the log set insert the front edge, pushing back down until the rear
tab snaps under the back ledge and the logs are resting against the mirror.