Desa (V)TC36N(-HA) Series, (V)TC36P(-HA) Series Outdoor Fireplace User Manual


  Open as PDF
of 44
 
www.desatech.com
116192-01G26
4. Remount the new frame at the hinge with ve
new screws before closing door. This will
ensure seating of the gasket.
5. Close glass door frame. Lock latches by placing
the bar under the tab on door and pushing down
and back on latch (see Figure 42, page 25).
6. Replace screen/rod assembly by reversing
step 1.
7. Replace louvers by reversing procedure
under Removing Louver Panels, page 25.

See Cleaning and Maintenance on page 31.


It is very important to keep logs exactly as
installed. Do not modify logs. Only use log set
designed for this replace. Logs under log/grate
assembly are attached to burner. Do not attempt to
move these logs as this will damage logs.


   

Open louvers, remove screen, unlock door latches
and open glass door. See Removing Glass Door,
steps 1 and 2, page 25.
1. Pull ember material apart into pieces no larger
than a dime. Place these pieces loosely and spar-
ingly directly onto the exposed front section of
the burner (see Figure 43). This will create
the glowing ember appearance as the ame
touches the ember material. Do not block air
slots by using too much ember material in one
area. It is not necessary to use all of the ember
material provided.
2. Pour lava rock onto plenum but not onto at
burner. It is not necessary to use all of the lava
rock provided.




FIREPLACE
INSTALLATION
Continued
3. Close glass door, lock door latches, replace
screen and close louvers (see Removing Glass
Door, steps 5 through 7).
  




Figure 43 - Placing Ember Material on
Burner
Ember Material
Plenum


   
     

You may purchase brick liner from your local
retailer or see Accessories, page 42.
CAUTION: Always handle
    
   


1. Remove top and bottom louvers to allow ac-
cess to door latches.
2. Unlock door latches and open glass door. See
Removing Glass Door, steps 1 and 2, page 25.
3. Carefully remove lava rock and ember mate-
rial. Remove log/grate assembly by unscrew-
ing grate from plenum. The two logs under the
grate are attached to burner. DO NOT attempt
to remove.
4. Remove screws that attach plenum to burner
to remove plenum.
5. Remove three screws from deector shield on
the inside top of rebox. Set shield and screws
aside.
 previous next