Desa (V)CD36TN Outdoor Fireplace User Manual


 
www.desatech.com
116035-01E38
LOGS
If you remove logs for cleaning, refer to Install-
ing Logs, Lava Rock and Glowing Embers, page
30, to properly replace logs.
Use a vacuum cleaner to remove any carbon
buildup on logs.
Replace log(s) if broken. See Replacement
Parts on page 44.
Replace ember material periodically as needed.
See Replacement Parts on page 44.
CLEANING AND
MAINTENANCE
Continued
TROUBLESHOOTING





Note: All troubleshooting items are listed in order of operation.
The two most common causes of a malfunctioning gas appliance are:
1. Loose wiring connections
2. Construction debris clogging the pilot and/or gas control valve lter

1. Ignitor electrode not con-
nected to ignitor cable
2. Ignitor cable pinched or wet
3. Piezo ignitor nut is loose
4. Broken ignitor cable
5. Bad piezo ignitor
6. Ignitor electrode broken
7. Ignitor electrode positioned
wrong
REMEDY
1. Reconnect ignitor cable
2. Free ignitor cable if pinched
by any metal or tubing. Keep
ignitor cable dry
3. Tighten nut holding piezo
ignitor. Nut is located behind
the mounting bracket
4. Replace ignitor cable
5. Replace piezo ignitor
6. Replace pilot assembly
7. Tighten electrode. Replace if
necessary

When ignitor button is pressed,
there is no spark at pilot

Conduct annual inspection of the venting system
following these guidelines:
1. Check areas of venting system that are exposed
to the weather for corrosion (rust spots or streaks
and, in extreme cases, holes). Have these items
replaced immediately by a qualied service
person.
2. Remove the vent cap and shine a ashlight
into the vent. Remove any foreign material.
3. Check for evidence of excessive condensation.
Continuous condensation can cause corrosion
of caps, pipes and ttings and can be caused
by having excessive lateral runs, too many
elbows or exterior portions of the system being
exposed to cold weather.
4. Inspect joints to verify that no pipe section or tting
has been disturbed and loosened. Check mechani-
cal supports such as wall straps for rigidity.