Desa (V)CD36TN Outdoor Fireplace User Manual


 
www.desatech.com
116035-01E 25
FIREPLACE
INSTALLATION
Continued
INSTALLING OPTIONAL WIRELESS



-


1. Open bottom louver and locate the switch
bracket on the right
2. Locate the battery clip mounted on the back
of the receiver. Slide a 9-volt alkaline battery
(not included) through the clip
3. Attach the terminal wires to the battery. (see
Figure 44).
4. Connect wires from receiver to TH and TPTH
to control valve (see Figure 43, page 24).
5. Locate the two plastic mounting clips provided
with the kit.
6. Use the clips to mount the receiver on remote
mounting bracket as shown in Figure 45.
Figure 44 - Attaching Alkaline Battery to
Receiver
9-Volt
Alkaline
Battery
Receiver
Terminal
Wires
Battery Clip
Figure 45 - Mountinig Remote Receiver
to Bracket


1. Remove battery cover on back of remote
control unit.
2. Attach terminal wires to a 9-volt alkaline
battery (not included). Place battery into the
battery housing.
3. Replace battery cover onto remote control
unit.
Figure 46 - Installing Battery in Hand-
Held Remote Control Unit
9-Volt
Battery
Battery
Housing
Battery Cover
Terminal
Wires
Remote Control Unit
Towards Front
REMOTE ON OFF
Remote Receiver
Plastic Mounting Clips
INSTALLING OPTIONAL WIRELESS



Receiver
1. Open bottom louver and locate the plug recep-
tacle. The plug receptacle is located either on
the right or left side of cabinet.
2.
The WRC model receiver does not require a bat-
tery. The receiver can be installed by rst plug-
ging the short extension cord into the replace
receptacle. Then plug the receiver unit into the
extension cord. Finally plug the ignition module
plug into the receiver unit (see Figure 47).
3. Activate the remote handset battery by re-
moving the insulating tab on the back of the
handset (see Figure 48, page 26). The battery
is included pre-installed.
Figure 47 - Connecting WRC Remote
Control Electronic
Fireplace
Receptacle
Extension
Cord
Remote
Control
Receiver
Ignition
Module Plug