Desa (V)CD36TN Outdoor Fireplace User Manual


 
www.desatech.com
116035-01E 29
FIREPLACE
INSTALLATION
Continued


1. Open equipment shutoff valve (see Figure 52,
page 28).
2. Open propane/LP supply tank valve for
propane/LP fireplace or main gas valve
located on or near gas meter for natural gas
replace.
3. Make sure control knob of replace is in the
OFF position.
4. Check all joints from equipment shutoff valve
to gas valve (see Figure 53 for propane/LP or
Figure 54 for natural gas). Apply noncorrosive
leak detection uid to all joints. Bubbles form-
ing show a leak. Correct all leaks at once.
5. Light replace (see Operating Fireplace, page
31). Check all other internal joints for leaks.
6. Turn off replace (see To Turn Off Gas to Ap-
pliance, page 32 or 35 depending on model).

DOOR
    


    
   -
tion see Replacement Parts,


   
    

    

  
-
-


1. Grasp the lower louver panel and pull up until
the hanger brackets release from the door pins
(see Figure 55).
Figure 55 - Removing Lower Louver
Access Panel
Door Pin
Hanger Bracket
Lower Louver
Access Panel
2. Swing the louver panel out until it clears the
replace opening.
3. Pull the entire panel out until the bottom tabs
are free of the slot openings in the lower face
frame.
Figure 56 - Removing Top Louver Trim
Panel
Panel Tabs
Top Louver
Trim Panel
Door Pin
Hanger
Bracket

1. Grasp the two hanger brackets at the bottom
and pull up until the hanger brackets release
from the door pins (see Figure 56).
2. Swing out the bracket ends until the upper
panel tabs can be angled out of the slot open-
ings in the upper face frame.
3. Pull the entire louver trim panel out of the face
frame.