Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
AssemblethereducedendsoftheR.H.support
tubesintotheendsoftheL.H.supporttubes.Fasten
thetubestogetherusingtwo1/4"x 1"curvedhead
bolts,insertedfromthetop,andtwo1/4"(SEMS)hex
nuts.Seefigure11.
1/4" x 1" CURVED
HEAD BOLT "_
I
/
1/4" HEX
NUT (SEMS)
SUPPORT
TUBE L.H.
SUPPORT
TUBE R.H.
FIGURE 11
Place the support tubes down into the front and rear
tube support brackets, with the tube's welded brack-
ets facing the center of the cart.
Assemble the top connecting tubes to the support
tubes using four 1/4" x 1-1/4" hex bolts and 1/4" hex
lock nuts. Tighten only until there is no end play in
bolt. Tubing should fold up when removed from cart.
See Figure 12.
1_" x 1-1_"
HEX BOLT 1_" HEX
LOCK NUT CONNECTING
\ /TUBE
To install the fabric cart cover:
1. Unzip the cover's rear flap and place the cover on
top of the support tubes, making sure that the
zippered flap is at the rear of the cart.
2. Pull the front of the cover down over the front
support tubes and hook the cover's plastic channel
under the cart's front flange.
3. Pull the sides of the cover down and hook the
cover's plastic channel under the cart's side
flanges.
4. Swing the rear flap up onto the top of the cover.
Starting at the top, secure the cover to the rear
support tubes with the three velcro straps on each
side. Tighten the straps so that the zipper is pulled
around behind the support tubes. The zipper
should close easily.
5. Unzip the rear flap to place the tailgate down into
the tailgate guides. See Figure 13.
Plasti_
Channel
FIGURE 13
FIGURE 12
12