Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
English-7
■ Proper location of the burner with respect to the orice is
important. To verify the proper installation of the venturi
tube, use a screwdriver to remove the grill top. The venturi
tube must be located over the orice tting. See Fig. 26
(grill top not shown).
CAUTION
DO NOT add charcoal or lighting uid!
■ Check and clean the burner/venturi tubes for insects and
insect nests. A clogged tube can lead to a re beneath
the appliance.
WARNING
Failure to follow these safety steps before using the grill
each time could result in a re that could be hazardous to
you, your appliance or property. It is especially important to
observe these steps after the grill has been stored, moved
or cleaned.
DANGER
TO PREVENT FIRE OR EXPLOSION HAZARD:
r NO SMOKING. DO NOT use or permit sources of
ignition in the area while doing a leak test.
r Perform leak tests outdoors only.
r NEVER perform a leak test with re or ame.
1. Make a soapy solution of equal parts mild liquid
dishwashing detergent and water.
2. Turn off all burner control knobs.
3. Apply a soap solution to the connections
indicated with the arrows. (Fig. 27) If bubbles
appear at these areas, a leak is indicated.
If you detect a leak:
1. Stop a leak by tightening the loose joint, or by replacing
the faulty part with a replacement part recommended
by Coleman. DO NOT attempt to repair the cylinder if it
should become damaged; the cylinder MUST be replaced.
2. If you are unable to stop a leak, remove the cylinder from
the grill. DO NOT use the grill until the leak is corrected.
When to test for leaks:
1. Perform a leak test each time the gas supply cylinder is
connected to the regulator. Leak test anytime a part of the
gas system is replaced.
1. Regularly check the burner venturi tubes for blockage
from an insect nest. Read “Cleaning the Venturi” in the
section titled “Care, Maintenance, and Cleaning”, and also
the section titled “Troubleshooting”.
2. Check that all the burner venturi [A] are set over the valve
outlets [B] correctly. The valve orice [C] must be inside
the venturi. (Fig. 28)
3. Use only the gas specied.
4. Keep the grill on a level surface.
5. Keep the grease pan empty at start up.
Burner and Orice
How to Check for Leaks
Fixing A Fuel Leak
Start-Up Check List
Leak Testing - Disposable LP Gas
Cylinders
REPRESENTATIVE ILLUSTRATION
A
C
B
Fig. 28
Orice Fitting
Burner
Fig. 26
Venturi Tube
No Smoking
No Flame
Fig. 27