Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
35
Installation Instructions
Step 4: Secure appliance into
housing unit
Note: The unit housing the appliance
must be appropriately fixed.
Method 1: Care must be taken to
ensure the appliance runners are
sufficiently engaged over the top of the
runners on the base units.
Method 2: Insert appliance into
cabinet - ensure that it is engaged over
the top of the side runners.
Method 3: Insert appliance into cabinet.
To secure appliance to housing unit
Note: Ensure that the appliance is
centrally located. Take care not to
damage the appliance or cabinet.
Note: For installation Method 1, you
will need to drill through the fixing
holes into the side trims with a 3.2mm
diameter drill.
There are 6 securing screws.
■ Open the grill / top oven door,
and screw 2 screws through the
top corner holes in the front frame.
■ With the grill / top oven door still
open, screw 2 screws through the
holes in the front frame, located
under the grill compartment.
Close the grill / top oven door.
■ Open the main oven door, and
screw the remaining 2 screws
through the bottom corner holes in
the front frame.
Close the main oven door.
Step 5: Installing a hob above
the appliance
When the appliance is installed under
a worktop, with a hob installed above
it, the installation instructions for the
hob must be read in conjunction with
these instructions.
When installing a gas hob above the
appliance, care must be taken to
ensure that the hob inlet pipe is as
close to the back wall as possible, so
that it does not obstruct the appliance
or the appliance inlet pipe.
If a flexible inlet pipe is used, it must
hang vertically and not be trapped
between the oven and rear wall.
Important: - ensure that you route all
mains and electrical cables and flexible
tubing well clear of any adjacent heat
source, such as an oven, grill or hob.