Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
14
Should you notice that your Burner(s) are getting hard to light or the flame is not as hot as it once was, refer to the
“How to Clean your Burners” section on page 20, to remove any possible obstructions.
Lighting the Grill Using the Pulse-Spark Ignitor
To reduce the risk of serious bodily injury or death from fire or explosion:
• During failed lighting attempts, or if the Burners go out during operation, turn Control Knobs “Off” to dissipate
any accumulation of gas. Wait five minutes before repeating lighting procedure.
• Light each burner from the left before lighting the next burning to prevent gas from accumulating.
WARNING
!
1. IMPORTANT: Make sure Control Knobs are turned “Off.” (Fig. 7)
2. Turn the LP Gas Cylinder valve open counterclockwise until it stops. (Fig. 8)
Fig. 7
Control Knob in
Off position
Control Knob in High position
(large flame symbol)
Igniter Button
Left Main Burner
Control Knob
Fig. 9
To reduce the risk of death or serious injury from an explosion or a fire beneath the grill:
• Regularly inspect and clean Burner/Venturi Tubes for insects or insect nests. Spiders or small insects can build nests,
webs, and lay eggs in the grill’s Venturi Tubes, (Fig 12, page 20) obstructing the flow of gas to the Burner. The backed-
up gas can ignite behind the Control Panel and cause a fire beneath the grill, posing the risk of death or serious bodily
injury. This is known as a “flashback.”
• Be sure Burners are re-installed properly before using grill.
WARNING
!
Fig. 8
Turn LP Gas
Cylinder valve
counterclockwise
3. Push Burner Control Knob in on Control Panel and turn counterclockwise to the High position. (Figs. 7 and
9)