Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
FAQ'S
Q: Why has the flow rate of the faucet reduced
significantly?
A: Check and clean aerator and strainer.
Q: Why do I here humming noise from under the deck
after faucet is turned off?
A: The humming noise is the temperture control motor.
The faucet has a default termperature setting, which is
controlled by the motor which rotates a cycling cartridge.
If you have adjusted the temperature during faucet use,
then after 15 second delay, the motor will rotate the
cartridge back to the default temperature setting.
Q: Why does the faucet operate the opposite of
expected-Turns On when not in sensor range, but turns
off when in sensor range?
A: Sensor wires to solenoid are reversed. Black to -
& Red to + is correct.
Q: What is the operating pressure range?
A: Faucet will operate with supply pressures ranging
from 20-80 psi.
Q: There is no flow out of faucet when I’m in sensor
range?
A: Open enclousure cover and verify that all electrical
connections are tight, specifically the Red & Black
sensor wire connectors to the wire plugs.
8
CAUTION
GENERAL CLEANING; Fig. 4
1. For general cleaning use a damp, soft cloth to clean
the spout and the sensor.
2. For cleaning dirt use a soft cloth with diluted dish
washing detergent. Wipe the area using a wet cloth
and dry using a soft cloth.
Do not scratch the sensor when cleaning.
Avoid using anything that may scratch the spout
surface. Never use polishing power, detergent or a
nylon scrub brush. They will damage the surface of the
spout or Sensor.
4
Fig. 4
M968857 REV.1.2