Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
OPERATION
When the Sensor detects a user, the water
immediately starts to flow. Water flow will stop Two
seconds after user is out of sensor range. The off delay
allows the user to comfortably move his hands without
the flow cycling on to off. As a precaution, a safety
timer will turn off the water, after the sensor has been
blocked for 59 seconds. The water will stay off until the
blockage is removed from the detection zone.
Output water temperature has a default setting. See
Section 3 for “How to Set Default Temperature.” To
change the output water temperature place one hand
within the On/Off Sensor range to activate faucet, then
place other hand within the Blue Sensor to decrease
water temperature, or the Red Sensor to increase
water temperature. Blue or Red LED will light up when
hand is within the sensor range. The Blue and Red
sensor ranges cannot be adjusted.
Note: If On/Off Sensor is not activated within 15
seconds of temperature adjustment, then the
faucet will adjust back to the default temperature
settings.
Detection Zone: 2" - 10" (50mm - 250mm)
Default: Set at Factory 6" (150mm)
Fig. 1
5
HAND WASH SENSOR OPERATION;
Fig. 1
1
DETECTION
ZONE
2
"
-10
"
(50mm-250mm)
1. Setting the Detection Zone (Distance):
Remove cover from ENCLOSURE. Disconnect GRAY
SENSOR WIRE (1) from circuit board, then reconnect.
Fig. 2.
2. While the SENSOR CONTROL LED (2) is blinking
slowly, place your hand 1 - 2 in. (30-50mm) in front of
the sensor. Fig. 2a.
3. When the LED stops blinking and stays "ON", move
your hand to the desired position and hold in place until
the LED begins to blink again. Fig. 2b.
4. Once the SENSOR CONTROL LED (2) begins to
blink again, remove your hand from the detection zone.
When the flashing stops, the detection distance is set.
5. Replace cover on ENCLOSURE.
HOW TO CHANGE ON/OFF
SENSOR RANGE;
(Factory set at 6") Fig. 2a, 2b
2
Fig. 2
Fig. 2a
BLINKING LED
1" - 2" (30mm - 50mm)
UP TO 10" (250mm)
2
BLINKING LED
2
BLUE
SENSOR
ON/OFF SENSOR
RED
SENSOR
Fig. 2
1
Fig. 2b
M968857 REV.1.2