Weber SUMMIT GRILL CENTER Gas Grill User Manual


  Open as PDF
of 32
 
26
www.weber.com
®
maintenance
Be careful not to break or disconnect the wires for the control panel lights.
Rest the control panel against the left side of the grill (A) exposing the valves, burners,
igniter, and manifold.
8) Removethetwoscrewsthatsecurethemanifoldtothecookbox.Pullmanifold
assembly out from the manifold frame.
9) Pull the selected burner(s) tube(s) from manifold frame and replace with a new
burner tube.
REMOVING THE SEAR STATION
™
BURNER
To remove the Sear Station Burner
™
, pull the burner tube toward you. This removes it
from the burner tube notch (a). Then rotate the tube clockwise (b), taking care to rotate
the burner tube so that the screw at the end of the tube (d) fits through the notch in the
heat shield opening (e). When the burner tube is free, remove it from the firebox (c).
10) Toreinstallthemanifoldassembly,reversesteps7through9.
m CAUTION: The burner openings (A) must be positioned
properly over the valve orifices (B).
Make sure the opposite end of the burner tubes (C) properly
align into the slots on the backside of the cookbox. Check
proper assembly before fastening manifold in place.
m WARNING: After reinstalling the gas lines, they should be
leak checked with a soap and water solution before using
the grill. (See, “Check for gas leaks.”)
A
8
9
A
B
C
a
b
c
d
e
 previous next