Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Buy Weber Grill Parts. It couldn't be easier. Find your Weber parts here.
j) Reinstall the Spider Stopper Guards. Slightly rotate
the Spider Stopper Guards so that the seams are in
line with the Venturi fins. There should be no gaps
in the seams or in the fit around the burners and
valves. Figure 21.
ƽCAUTION: If the Spider Stopper Guards do not fit
tightly, contact Weber-Stephen Customer Service.
ƽCAUTION: After reinstalling the gas lines, they
should be leak checked with a soap and water
solution before using the barbecue. (See Step
"Check for gas leaks".)
38
Crossover Ignition System Operations
If the Crossover Ignition System fails to ignite the Front
burner, light the Front burner with a match. If the Front
burner lights with a match, then check the Crossover
Ignition System.
■ Check that both the white and black ignition wires
are attached properly. Figure 22.
■ Check that the Crossover Ignition button pushes the
igniter (button) down, and returns to the up position.
■ Check to see if the igniter is loose in the frame.
Tighten if necessary; see Step “Install igniter” for
correct procedure.
If the Crossover Ignition System still fails to light, contact
Weber-Stephen Customer Service.
Figure 22
White wire
Black wire
Venturi fin
Check fit around burner
Figure 21
Check fit around
valve