Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Buy Weber Grill Parts. It couldn't be easier. Find your Weber parts here.
19
Figure 22
View from rear
of barbecue
Hinge rod
Figure 23
Figure 24
To lower table: Pull support rod up to disengage slide
lock and lower table. To raise table, lift table up and
engage slide in locked position. Figure 24.
F
F
Notch
Slide bar
Unlocked position
Slide
Support rod
Locked position
Wheel frame
View from front
of barbecue
Slot in frame
(view from below)
Insert one end of the hinge rod into the hole in the
frame. Figure 22 (a).
Insert the other end into the hole in the swing table end
bracket. Figure 22 (b). Hold the end bracket at an angle so
the lower tab is inside the frame tube. Push the bracket into
the frame. Check to see that the lower tab of the bracket is
hooked in the slot in the frame. Figure 22 (c).
To fully seat the bracket, you may have to tap it lightly with a
hammer.
ƽWARNING: If swing table end bracket is in any
way cracked or damaged, do not use swing table.
Call our Customer Service Center to order a new
part.
ƽWARNING: The load limit for the swing table is
30 pounds.
(b)
(c)
(a)
Position slide bar assembly on the outside of the wheel
frame. Put a nylon washer on each 1 3/4 inch screw,
insert screws through wheel frame and slide bar
assembly and add nylon washers and hex nuts. Tighten
nuts using a screwdriver and pliers. Figure 23.