Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Buy Weber Grill Parts. It couldn't be easier. Find your Weber parts here.
17
Slot in frame
(view from below)
Insert one end of the hinge rod into the hole in the
frame. Figure 18 (a).
Insert the other end into the hole in the swing table end
bracket. Figure 18 (b). Hold the end bracket at an angle so
the lower tab is inside the frame tube. Push the bracket into
the frame. Check to see that the lower tab of the bracket is
hooked in the slot in the frame. Figure 18 (c).
To fully seat the bracket, you may have to tap it lightly with a
hammer.
ƽWARNING: If swing table end bracket is in any
way cracked or damaged, do not use swing table.
Call our Customer Service Center to order a new
part.
ƽWARNING: The load limit for the swing table is
30 pounds.
Figure 18
(c)
View from rear
of barbecue
Hinge rod
(b)
(a)
Step 15
Install left hand swing table
You will need: swing table end bracket, two 10-24 hex
nuts, two 10-24 x 1 3/4 inch machine screws, left hand
slide bar assembly, swing table, four nylon washers,
screwdriver and pliers.
Allow the slide bar to hang down. Push the support rod
into the lower support bracket. Figure 17 (a). Swing the
rod up so you can slide the rod all the way inside the
locking tab. Figure 17 (b). The rod should swing freely
inside the locking tab. Figure 17 (c).
Figure 17
(a)
(b)
(c)
Support rod