Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Buy Weber Grill Parts. It couldn't be easier. Find your Weber parts here.
24
Step 26
Complete accessory installation
You will need: work table, two accessory trays, Warm-Up
Basket, warming rack, thermometer, two tubing plugs and
a hammer.
Insert one end of the Weber Warm-Up Basket into the hole
in the right end of the lid and the other end into the slot in
the left end of the lid. Figure 38 (a).
Set the work table onto the left side rails. Figure 38 (b).
Set the accessory trays between the two frame connectors.
Figure 38 (c).
Open the lid and set the warming rack into the slots at the
rear of the cooking box. Figure 38 (d).
Insert the thermometer into its holder. Figure 38 (e).
Insert tubing plugs into the ends of the frame. To fully seat
the plugs, you may have to tap them lightly with a hammer.
Figure 38 (f).
Figure 38
(a)
(d)
(e)
(f)
(b)
(c)
Figure 36
Figure 37
To lower table: Pull support rod up to disengage slide lock
and lower table. To raise table, lift table up and engage
slide in locked position. Figure 37.
F
F
Notch
Slide bar
Unlocked position
Slide
Support rod
Locked position
Wheel frame
View from front
of barbecue
Position slide bar assembly on the outside of the wheel
frame. Put a nylon washer on each 1 3/4 inch screw, insert
screws through wheel frame and slide bar assembly and
add nylon washers and hex nuts. Tighten nuts using a
screwdriver and pliers. Figure 36.
ƽCAUTION: To keep the barbecue stationary, the tabs
on the locking casters should be in the down position.