Weber 3200 Gas Grill User Manual


 
12
Step 7
Install side burner locks
You will need: frame assembly, two side burner locks and
a 7/16 inch wrench.
Loosen the right rear 1/4 x 20 bolt. Install the side burner
lock. The “U” shape cut out of the lock slips down over the
bolt. Tighten with a wrench. Figure 6 (a).
Loosen the right front 1/4 x 20 bolt. The side burner lock
fits between the front panel and the frame. The “U” shape
cut out slips up over the bolt. Tighten with a wrench.
Figure 6 (b).
Burner tubes
Figure 7
Frame brace
Step 8
Add cooking box
You will need: frame assembly, cooking box assembly,
spacer bracket, 1/4-20 x 2 inch bolt, nylon washer,
1/4-20 keps nut, pliers and a 7/16 inch wrench.
Uncoil the hose.
Set the cooking box into the frame so the burner tubes are
under the frame brace. Figure 7.
Figure 6
Slide the cooking box to the left within the frame. Put the
washer on the bolt. Take the spacer bracket and hold it up
to the frame making sure both tabs fit underneath the frame
cross piece. Figure 8 (a). Insert the bolt through the center
hole in the spacer bracket, frame and cooking box with the
head of the bolt outside the spacer bracket. Figure 8 (b).
Add the keps nut. Figure 8. Tighten by holding the bolt with
pliers while you tighten the nut with a wrench.
Figure 8
Frame cross piece
Spacer bracket
Keps nut
Bolt
Nylon washer
(a)
(b)
(a)
(b)