Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Buy Weber Grill Parts. It couldn't be easier. Find your Weber parts here.
14
Step 11
Install igniter
Note - The igniter wires are already attached to the Gas
Catcher Ignition Chamber and the igniter. This was done to
factory test the ignition system.
The igniter lock nut is on the igniter.
Route the igniter and wires as shown. Figure 12 (a).
Insert the top of the igniter up through the large part of the
keyhole in the frame brace. Figure 12 (b). Loosen the igniter
lock nut and slide the igniter to the small part of the keyhole.
Figure 12 (c). Tighten the igniter lock nut.
Note - If the igniter works loose, carefully tighten the igniter
lock nut with an adjustable wrench or pliers.
Figure 12
(a)
(b)
(c)
Igniter lock nut
Keyhole in
frame brace
Small part of
keyhole in
frame brace
Frame brace
Step 10
Add fuel scale
You will need: fuel scale assembly, two 1/4-20 wing nuts
and two nylon washers.
Slip the bolts on the back of the fuel scale assembly
through the two small holes in the tank panel. Add
washers, then wing nuts and tighten. Figure 11.
F
E
F
E
Figure 11
View from front left View from front right