Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Tolightthesideburners:
Firstremovetheburnercoveror anycookingutensilfromthe
burnergrate.
_i CAUTION:Thesideburnercovermaybehotif thegrillburners
areinoperation.PushandturnthecontrolknobuntiltheHigh
positionalignswiththeindicatorlineonthecontrolpanel.
Immediatelypresstheelectronicignitionbuttoncorrespondingto the
burnersbeinglit untiltheburnerislit or until4 secondspass.Ifthe
burnerdoesnotlightafterseveralattempts,wait5 minutesto allow
anyaccumulatedgasto dissipate.Iftheburnerwillnotlightafter
severalattempts,thentheburnercanbematchlit byholdinga lit
matchnextto the burnerports. Pushandturnthecontrolknobuntilthe
Highpositionontheknobalignswiththeindicatorlineonthecontrolpanel.
TolightTruSearTM infraredburner (ifapplicable):
Beforelighting the burner,remove the stainlesssteel cover. Pushin,turn the
TruSearTM infraredcontrol knob until the High position on the knob aligns with
the indicator lineon the control panel and continue to hold the knob in. Press
the electronic ignition button which corresponds to the control knob. You will
hear aclicking sound. After the burner lights, hold the control knob in for
about 5 seconds longer or until the burner remainslit. Once lit,turn the
control knob to the desired setting. Ifthe burner does not light within 4
seconds,releaseand turn the control knob to "off". Wait 5 minutesfor any
accumulated gasto dissipate. After severalfailed attempts the burner canbe
litwith a paper book match.
Ughting the Grill (E-SeriesModels)
To light the grill / smoker burners:
Make sure the unit is plugged into a properly grounded
receptacle. Turn the appropriate control knob counter clockwise to any
position. This control is both a gas valve and an electric switch.
Burners will ignite at any "on" position with the automatic reignition
system. If the flame goes out for any reason, the burners will
automatically reignite if the gas is still flowing. When gas is permitted
to flow to the burners, the electric igniters start sparking. On all
surface igniters you should hear a "clicking" sound. If you do not, turn
off the control and check that the unit is plugged in and that the fuse
or circuit breaker is not blown or tripped.
Within a few moments, enough gas will have traveled to the
burner to be able to light. When the burner lights, turn the burner
control to any position to adjust the flame size.