Sierra Products UV360FP Outdoor Fireplace User Manual


 
9
WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property
damage, personal injury or loss of life.
FOR YOUR SAFETY, KEEP FIRE SCREENS CLOSED WHILE IN OPERATION .
OPERATING INSTRUCTIONS FOR MANUAL SAFETY VALVE
FOR YOUR SAFETY READ BEFORE LIGHTING
A. This appliance has a pilot which must be lighted by hand. When lighting pilot follow these instructions
exactly.
B. BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because
some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS;
M Do not try to light any appliance.
M Do not touch any electric switch; do not use any phone in your building.
M Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions.
M If you cannot reach your gas supplier, call the fire department.
C. Use only your hand to push in or turn the gas control knob, NEVER use tools. If the knob will not push in
or turn by hand don't try to repair it, call a qualified service technician. Force or attempted repair may
result in fire or explosion.
D. Do not use this appliance if any part has been under water. Immediately call a qualified service technician
to inspect the appliance and to replace any part of the control system and any gas control which has been
underwater.
LIGHTING INSTRUCTIONS
1. STOP! Read the safety information above before proceeding.
2. Push in gas control knob slightly and turn clockwise to "OFF".
NOTE: Knob cannot be turned unless pushed in slightly. Do not force.
3. Wait five (5) minutes to clear out any gas. If you then smell gas, STOP!
Follow "B" in the safety information above. If you don't smell gas, go to next
step.
4. Locate the pilot burner on the back side of burner.
5. Turn knob counter clockwise to Pilot. Push control knob all the way in and
hold in, immediately lighting the pilot with a match. Continue to hold the
control knob in for about 1-1/2 minutes after the pilot is lit. Release knob
and it will pop back up. Pilot should remain lit. If it goes out, repeat steps 2 through 5.
M If knob does not pop up when released, stop and immediately call your service technician or gas
supplier.
M If the pilot will not stay lit after several tries, turn the gas control knob to "OFF" and call your service
technician or gas supplier.
6. Turn gas control knob counterclockwise to "HI".
TO TURN OFF APPLIANCE
1. Push in gas control knob slightly and turn clockwise to"OFF". Do not force.
2. Close access door.