Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
8
Figure 18 - Setting logs and lava rock
Figure 18A- Finished log & rock placement
Figure 19 - Control and Ignitor Access
PLACING LOGS AND LAVA ROCKS
Assemble ceramic logs by placing the large base log to
the rear of grate assembly (Figure 18). Add front logs
with “burned through” features to front left and right.
Place lava rocks on center of burner. Stack top logs
vertically in center of log stack. Adjust as required to
provide realistic flame.
(Warning: If flames get trapped under logs the result
will be black soot on logs and front face of fireplace.
Take extra care to adjust logs to correct this
condition).
OPERATING YOUR NEW APPLIANCE
When the appliance is being operated for the first time,
allow for a supervised burn of 30 minutes. Then shut the
appliance off and let it cool completely before relighting.
This allows proper curing time for the logs. (After several
hours the logs will discolor slightly, this is normal.)
MAINTENANCE
It is recommended that a competent serviceman perform
the following procedures at least annually;
WARNING: Any change to this fireplace or its co-
mponents can be dangerous. Any safety screen or guard
removed from fireplace for servicing must be replaced
prior to operating the heater. At the beginning of each
heating season, have a qualified technician inspect the
burner and pilot burner area for dust or carbon build-up.
This may be removed from the burner or logs with a soft
bristle brush. A visual inspection of the pilot burner and
main burner flame should be performed to verify proper
operation, refer to operating instructions for proper
adjustment. Care should be taken when cleaning and
handling logs since they become brittle with use. Small
heat cracks in the logs do not affect the operation of the
log set.
Cleaning Stainless Steel
General cleaning may be accomplished by using a
household cleaning solution and warm water. The
exterior may be cleaned using the same method. Badly
soiled or tarnished areas can be clean using a “scotch
brite” pad. Always scrub in same direction of material
finish.
Do not use caustic cleaners on fireplace as it may cause
damage to control and electric components.
CUSTOMER SERVICE& PARTS
REPLACEMENT:
Parts and accessories may be purchased from your local
dealer or directly from Sierra Products, Inc. Orders will
be accepted by mail, or you may call your order in Mon-
day through Friday from 1:00 p.m. to 5:00 p.m. (Pacific
Standard Time) at: (909) 399-3355.
Please, fill in the following information for future
reference and warranty verification;
Date of Purchase ____________________20____
Model # ________________
Serial # ___________________________________
TROUBLE SHOOTING
If pilot or main burner will not light:
1) Make certain gas supply is turned "ON.”
2) Make certain all air is bled from system.
3) Make certain you have followed the safety and
operating instructions.
4) Call a qualified repair person to inspect the appliance.
5) When high winds are present, as a safety feature the
pilot burner will not stay lit. Do not operate in high
winds.