Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Page 18 NDA-30016 Revision 3.0
MAT Assignments Roamer Installation Guide
Assignment of Numbering Plan to Support Free Location Feature
ANPD Command:
(Assignment of
Numbering Plan
Data)
This command is used to assign the actual first digit and the total number of digits
for the set of physical numbers and again for the logical numbers. For instance, if
the physical numbers are to be four digits long and lie in the range between 3000
to 3999, the first digit is 3 and the total number of digits is 4. The logical numbers
can be the same first digit and total number of digits. Remember, use the same
tenant number that was configured for Roamer.
ASPA Command:
(Assignment of
Special Access
Code)
This command is then used to associate the first digit, assigned through ANPD,
with a kind of service. In ASPA, assign the logical and physical number(s) from
ANPD to STN – Station Number Level. Use the tenant number configured for
Roamer and the same connection status index that was used in ANPD.
ASDT Command:
(Assignment of
Station Data)
Finally, this command is used to associate each physical (station) number from
ANPD to the actual D
term
,
or station, Line Equipment Number (LENS) and
telephone class. Again, use the same tenant number.
Note:
Now that MAT assignments for logical and physical numbers are complete and
correspond to the Roamer database, when a telephone user enters a logical num-
ber, the NEAX performs the following processes:
a. It reads the first digit and the total number of digits according to the ANPD
assignment.
b. It finds that the first digit is assigned to station service through the ASPA.
c. It checks to see if the Free Location Feature (FLF) is enabled.
d. If FLF is enabled, from its database Roamer provides the physical number
associated to that logical number.
e. Then the NEAX reads the ASDT to find out what actual D
term
is associated to
that physical number and makes the change in assignment.
Roamer is installed and ready to be initialized. Enter the APM Operations Menu
and initialize Roamer through the Non-CRT Application Control option according
to instructions provided in the
APM Operations Manual
.