Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Page 8 NDA-30016 Revision 3.0
Application Configuration Roamer Installation Guide
Step 4: Secondary OAI Configuration Parameters
Using the OAI-Conf command on the APM Configuration Entry screen, make the
entry shown for each of the following parameters required by Roamer. Use the
instructions provided for this option in the APM Operations Manual:
Parameter Entry Description
Database Name #1* /oai/db/cur/
roamerdb
The path name of the database
containing user information. The
database filename roamerdb,
shown here with its path, should
be used as the name of the
corresponding Application
Definition File. For more
information see Chapter 3,
“Database Requirements” on
page 11.
Timeout Value #1 60 The number of seconds Roamer
waits for user numeric input
before it releases the D
term
.
Timeout Value #2 20 The number of seconds Roamer
waits for input of processing
symbols such as # before it
releases the D
term
.
Tenant Number 1 This configuration applies to
tenant No. 1.
Source Link Name OAI1X25 The port on the source side of the
communication link. Entry
should correspond to a Link
Name in the APM System
Configuration file.
Destination Link Name PBX1X25 The port on the destination side of
the communication link.
Association Recovery 10 The number of seconds Roamer
waits before trying to re-establish
an association with the NEAX
that has been released.