Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
20
W415-0381 / E / 02.09.06
the log resting in the pocket of the left crossover log.
5. Place the bottom of the right crossover log (#6) against
the right side of the grate. Place the top into the pocket
provided on the center log (#5).
Randomly place the charcoal embers along the front and
sides of the log support tray in a realistic manner. Fine
dust found in the bottom of the bag should not be used.
Sprinkle vermiculite around the charcoal embers.
Note: Both charcoal embers and vermiculite are not to
be placed on the burner.
Place the lumps between the logs in a realistic manner
taking care not to block any of the burner ports.
INSTALLATION TO BE DONE BY A QUALIFIED INSTALLER
and must be electrically connected and grounded in ac-
cordance with local codes. In the absense of local codes,
use the current CSA C22.1 CANADIAN ELECTRICAL CODE in
Canada or the ANSI/NFPA 70 NATIONAL ELECTRICAL CODE in the
United States
If the fireplace was not previously equipped with a
blower: route a grounded 2-wire, 60hz power cable to the
receptacle / junction box. At this point, it must be strain
relieved and insulated.
The three slots on the
blower mounting
the front row of ports covering all of the burner area in front of
the small logs (#2 & #3). Care should be taken to shred the
embers into
thin, small irregular pieces as only the exposed
edges of the fibre hairs will glow. The ember material will
only glow when exposed to direct flame; however, care should
be taken to not block the burner ports. Blocked burner ports
can cause an incorrect flame pattern, carbon deposits and
delayed ignition. PHAZER
TM
logs glow when exposed to di-
rect flame.
4. Cradle the notch on the bottom of the left crossover log
(#4) around the left side of the grate and the top into the
pocket provided on the back log. Place the end of the center
log (#5) against the grate, as shown, with the other end of
GLOWING EMBERS
LOG PLACEMENT
GRATE INSTALLATION
The grate for this fireplace has been removed for shipping
purposes.
The grate must be installed before the logs are installed.
Remove the packaging from the grate and install onto the
two pins as illustrated.
#2
#3
#4
#5
#6
#1
FIGURES 40a-d