Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
17
Natural gas hose for Optimum cart mount:
The natural gas cart
uses a 12 foot hose with
a quick disconnect
(supplied). The hose
passes beneath the heat
shield through the front
access opening and
connects directly to the
control valve. The quick
disconnect end attaches
to the gas supply line at
the shut-off valve.
(Fig. 28)
JNR & WNK Assembly Instructions
Step 2: Continued
D. Optimum Console Mount Gas Connections
All Optimum Console mounts:
The supply line connection pass beneath the heat
shield and through the
front slot with the pro-
tected edge and at-
taches to the valve.
Don’t forget to attach the
front Access Panel to
the Optimum Console.
(Fig. 25)
LP Propane for Optimum cart and pedestal
mounts:
The hose connection
from the Gaslow/
Regulator passes out the
front access opening;
resting on the protected
slot edge beneath the
control panel. The LP
tank locking bar will
press against the tank as
it is lowered into place to
prevent tank movement.
(Fig. 26)
Natural gas for Optimum pedestal mount:
The gas line enters at the rear of the base curving up
through the base opening.
The stainless steel flexible
tubing line must be con-
nected to the incoming gas
line using a
3/8
" flare cou-
pling (not supplied by
MHP). The flexible tubing
then passes beneath the
heat shield and through
the front access opening
and attaches to the control
valve. (Fig. 27)
See page 26 for tubing
bending instructions.
Step 3: Attaching the Side Shelf
(Fig. 29)
1. Turn NuStone Shelf upside down, noting the hole
location of the (2) Brass Treaded Inserts.
2. Lay Aluminum side shelf bracket onto shelf and
mount NuStone Shelf with supplied ¼-20 x 1¼"
Phillips head bolt and Lock washers. Do not
over tighten.
3. Attach the entire unit to the grill head by inserting
two ¼-20 x 1½" Rd. Hd. Sltd screws. Insert bolt
through the holes located on either the right or left
side of the bottom grill head, fasten with a ¼-20
Kep nut.
(Note: Repeat steps 1 and 3 to attach the WNK
model second side shelf.)
Tighten all gas connections securely and leak test
both ends. See Leak Testing on page 23.