Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
10
Mountings
Stainless Steel Optimum Console
Assembly Instructions
• The JNR, WNK or TJK model grills may be
mounted on the Optimum Console.
• The gas supply may be either LP or
Natural.
• The grill head should not be attached to the
Optimum Console until the console is
completely assembled
• The Optimum Console comes in two car-
tons—Box A contains the console and all
associated hardware. Box B contains either
the pedestal or cart base and all base
hardware.
Please check to be sure that all parts are included
before proceeding. Contact your dealer if any parts are
missing.
Parts Quantity
BOX A
Stainless Steel Front Panel 1
Stainless Steel Console 1
Stainless Grease Cup 1
Tank Lock Bar 1
Hardware Kit
Nylon Lock Bar Spacers 2
¼ - 20x1¼" S.S. Hex Head Bolts 4
¼ - 20 S.S. KEP Nuts 12
¼ S. S. Washers 10
¼ - 20 x ¾" S.S. Hex Bolts 8
Rectangular Washers 4
2-piece Gasket 1
BOX B
Cast Aluminum Base 1
12’ Nat. Gas Hose/Quick Discount 1
(Cart Nat.
Gas Only)
Stainless Steel Flexible Tubing, 28”
1
(Pedestal Nat.
Gas Only)
Axle 1
(Cart Only
)
Axle Clips 2 (
Cart Only)
6 " Wheels 2
(Cart Only)
Hub Caps 2
(Cart Only)
Step 1: Connect the Tank Locking Bar
(Fig. 10)
1. From box “A” locate and attach the Tank Lock Bar
across the back of the pedestal column. Use the ¾"
S.S. Hex bolt, Nylon Lock Bar Spacer and a Kep nut
on each side to fasten the Tank Lock Bar in place.
This spreads and holds the correct spacing at the
back of the column.
Step 2: Attach the Base to the Pedestal
(Fig. 11)
1. Before bolting the pedestal column to the base, the
2-piece gasket must be installed to create a barrier
between the two metals. Remove the backing strips
from the gasket to expose the adhesive and stick
the gasket to the bottom lip of the pedestal column.
Make sure to align the holes.
2. Attaching the pedestal column to the base will be
easier to handle by laying the pedestal column face
down and matching the holes on the pedestal col-
umn lip to the holes on the base. Use six ¾” bolts,
four large rectangular washers, and on the under-
side six round washers and KEP nuts.
IMPORTANT: the large rectangular washers are
used at the sides on top of the pedestal column lip.
The round washers and KEP nuts are used under
the base. Tighten securely and stand unit upright.
Note: While assembling, peel the thin white protective film
covering the stainless steel surfaces, especially in areas
which will be partially hidden after assembled. Do Not
Scrape off.