Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
21
Problem
Possible Cause
Solution
Burners will not light
using the ignitor
Burners not assembled
correctly
Not holding ignitor switch
long enough for pulse spark
No spark
LP- gas cylinder is empty
LP-Coupling nut is not fully
connected to regulator
LP-Excess flow valve tripped
in regulator
Obstructions in burners
Electrodes and burners are
wet
Wire loose or disconnected
Wire shorting (sparking
between ignitor and electrode
See Burner Maintainance re-assembly after cleaning.
When lighting the 1st (Leftmost) Burner, push control knob in
and turn counter-clockwise to the “High” position. Pause 4
seconds, then depress the ignitor button rapidly for 4-5 seconds
to light the burner.
1-Make sure all the wires are connected and to the right
terminals.
2-Check the battery. Make sure it is pushed in the holder.
3-Gas collector tab is bent (making too large or small of a gap
between electrode and tab). By hand, bend gas collector tab
back within a maximum of 3/16” gap to electrode. (See page
16 for illustration).
Take LP gas cylinder to licensed LP gas supplier to be refilled.
Tighten coupling nut by hand about one-half to three quarters
additional turn. Do not use tools.
Turn control knobs to “off” position and turn LP gas cylinder
handle clockwise until it stops. Wait five minutes. Relight LP
gas grill.
Clean burners (See Burner Maintenance in Cleaning and
Maintenance section of this manual)
Dry electrode with clean cloth. Air dry or use blow dryer.
Reconnect the wire.
Replace ignitor wire/electrode assembly (Call the Customer
Service Department).
TROUBLESHOOTING
STORAGE
To reduce the risk of serious bodily injury or death:
· Store your LP gas grill in a cool dry place. Do not
store an LP gas cylinder in a space greater than 125
degrees Fahrenheit. Do not store an LP gas cylinder
in a building ,garage or any enclosed area.
· Do not store an LP gas cylinder indoors (empty or
filled). Disconnect the LP gas cylinder from the gas
grill and store it outdoors out of the reach of children.
The gas grill may then be stored indoors.
· To avoid an explosion, do not leave an LP gas
cylinder inside a vehicle that can become overheated
by the sun.
· Even though your LP gas cylinder may appear to be
empty, gas may still be present and the cylinder
should be transported and stored accordingly.
· Do not store a spare LP gas cylinder under or near
the LP gas grill.
· Always turn off the gas cylinder at the LP cylinder
valve when the gas grill is not in use.
1) Disconnect LP gas cylinder from grill and store outside, in
a dry, well-ventilated area, away from any sources of heat
or ignition. Re-cap LP cylinder valve with the Safety Cap.
2) Remove Burners and wrap with aluminum foil to prevent
insects from entering the burner holes. Store wrapped
Burners on top of cooking grid.
3) You may wrap the Cooking Grid and Flame Diffusers in
aluminum foil and place inside the Hood or store inside
your dwelling.
4) Place a grill cover over the grill and store the gas grill
outdoors if possible. It may be stored indoors only if the
cylinder or the the natural gas line is disconnected from
the gas grill.
5) Before next use, remove aluminum foil and reinstall
Burners, Flame Diffusers, ceramic briquette trays and
Cooking Grids.
6) Before using the grill after periods of storage or non-use
(i.e. over winter), check your LP gas grill for gas leaks,
deterioration, proper assembly, and burner obstructions.
7) Periodically check and tighten all nuts, bolts, and screws.